Well Pump Repair in Bath, ME
No water or low pressure? We diagnose well pumps, pressure tanks and switches fast and get your water back.
Well Pump Repair for Bath Homeowners
RJC Plumbing handles well pump repair for homeowners throughout Bath. We run out of Augusta, so response times stay quick and every job benefits from already knowing the local housing and permitting.
No water, low or surging pressure, or a pump that runs constantly — RJC Plumbing diagnoses and repairs well pumps, pressure tanks, switches and controls for homes on private wells across Augusta and Central Maine.
Signs your well pump or pressure tank needs service
No water at the taps, pressure that surges or drops in the shower, a pump that clicks on and off every few seconds, or a pump that never shuts off. Each points to a different part of the system.
Short-cycling is usually a waterlogged pressure tank. A pump that runs constantly may be a leak in the well line, a bad check valve or a failing pump. No water at all is often the pressure switch or the pump itself.
How do we diagnose a well system?
We check the pressure switch and tank first — they are the most common failures and the least expensive. Then power to the pump, the control box on jet and some submersible systems, and pressure on the well line.
One Augusta-area customer with a failed pressure tank had us on site within 20 minutes and water back in two hours. That is the standard we aim for on no-water calls.
Pressure tank replacement
A pressure tank with a failed bladder makes the pump cycle constantly and shortens its life. We replace it with a correctly sized tank, new tee, gauge, relief valve and pressure switch, and set the air pre-charge to match.
Well pump replacement
When a pump has failed we replace it and the connections, sized to the well depth and household demand. Jet pumps on shallow wells are repaired or replaced above ground, usually in an afternoon.
If the problem is the well itself — a dry well or a collapsed casing — we will tell you straight away and point you to a well driller rather than sell you a pump you do not need.
Why Bath Chooses RJC Plumbing
- We run trucks through Bath regularly, not as an occasional out-of-area trip
- Every job starts with a free estimate, no obligation attached
- Active leaks, burst pipes and no-water calls go to the front of the line
- A fully licensed and insured Master Plumber, and a real person picks up when you call
Bath's Homes and Plumbing
Bath’s median home was built in 1938, and 58% of the city’s housing predates 1940 — the oldest stock of any town on our list. Homes like these routinely have galvanized supply lines, cast-iron drains and early copper behind the walls, all of it original enough to be past due. Our pipe repair and repiping service replaces failing sections with copper or PEX and pressure-tests the line before the wall goes back up.
Exterior work on a building inside the Bath Historic District needs Planning Board review, though the city says it is often completed administratively in as little as three days. That review is about the outside of the house, not what happens behind the walls, so it rarely slows down a bathroom or kitchen plumbing job.
Family-Owned, Not a Franchise
RJC Plumbing is a family-owned company based in Augusta, serving Bath since 2022. Owner Riley Campbell is a Master Plumber, and the crew that shows up is the same one that answers the phone. We would rather earn the next call than upsell this one.
Bath at a Glance
What the housing stock, water and sewer setup mean for a plumbing job here.
8,815
Population (Census / ACS estimate)
Median year built: 1938
Galvanized steel and early copper are common — a lot of homes here predate 1940.
Water
Bath Water District (BWD)
Sewer
City of Bath Public Works (Division of Storm Water and Sewers)
Natural Gas
Maine Natural Gas (MNG), a Unitil company
Code Office
City of Bath Code Enforcement Office
Main Heating Fuels (relevant to water heater choice)
- Heating oil 47%
- Propane 20%
- Electricity 20%
- Other 14%
Sources: censusreporter.org · en.wikipedia.org · cityofbathmaine.gov · cityofbathmaine.gov · cityofbathmaine.gov · cityofbathmaine.gov
Codes & Permits for Well Pump Repair in Bath
In Bath, plumbing permits come from the Local Plumbing Inspector at the City of Bath Code Enforcement Office (55 Front St., Bath, ME 04530, (207) 443-8330). With 8,815 residents, Bath is required to enforce the Maine Uniform Building and Energy Code (MUBEC). Part of the City's sewer system uses combined sewers that can overflow during heavy rain, prompting ongoing infrastructure upgrades (e.g., the Harward Street sewer/pump station project).
- Well pump replacement in Maine requires a licensee under the Well Drillers and Pump Installers Rules (10-144 CMR Chapter 232), administered by the Maine Water Well Commission, a body within the Maine CDC/DHHS created under 32 M.R.S. Chapter 69-C. maine.gov
- The Maine Plumbers' Examining Board (within the Office of Professional and Occupational Regulation, Department of Professional and Financial Regulation) licenses plumbers statewide and maintains the plumbing rules and laws (Title 32, Chapter 49); day-to-day permit issuance and inspection for a given town is carried out locally by a Local Plumbing Inspector (LPI), who is often the same person as the municipality's Code Enforcement Officer. maine.gov
How RJC Plumbing Handles Well Pump Repair in Bath
- Where Bath Water District (BWD)'s lines don't reach in Bath, homes rely on a private well — when pressure drops or a pump short-cycles, we diagnose which of the three usual parts failed.
- Well pump replacement in Maine has to be done by a licensee under the state's Well Drillers and Pump Installers Rules, and we hold to that standard on every well pump repair job.
- Maine CDC estimates roughly one in ten private wells statewide has too much arsenic, uranium, radon or another harmful substance, and recommends yearly bacteria/nitrate testing plus a broader test every three to five years — worth doing alongside a pump repair, not instead of it.
A granite Gothic-style church along Washington Street in Bath, a few blocks from the Chocolate Church Arts Center.
Street View © Google
“very thorough and professional. took the time to explain possibility of results, I would use their service again and recommend to anyone”
emily h
September 2026
“Great communication and service. Josh provided an estimated arrival time on the day and was on time. The service was quick and professional. I also really liked that there was someone on the office. Madison provided excellent updates and communication.”
Daniel Philbrick
July 2026
“Great service and communication! I've been very pleased with their work!”
Marina Savage
July 2026
“Riley and his crew are awesome guys! They handled all the plumbing in our new bathroom. They were efficient and finished the project in the timeframe they had quoted. Riley and his guys made us feel so comfortable that we left him at our home alone while we ran errands.”
Michael Giroux
June 2026
“RJC came to do all the plumbing for our new bathroom. They always came on time and their professionalism was particularly noteworthy. They also kept their workspace clean and were respectful of our home. I would highly recommend them.”
Mudiwa Mupotsa-Giroux
June 2026
“Riley called to let us know when he would arrive. He was very knowledgeable, polite, and answered all of our questions. The work completed was very professional and thorough. We hope to use them again.”
Paul Perzanoski
June 2026
Well Pump Repair Questions from Bath Homeowners
I have no water at all — what should I check before calling?
Check the breaker for the well pump and look at the pressure gauge on the tank. If the breaker is on and the gauge reads zero, call us. Do not keep resetting a breaker that trips; it can damage the pump.
Why does my well pump turn on and off constantly?
Short-cycling is almost always a waterlogged pressure tank with a failed bladder, or one with the wrong air pre-charge. It is a quick diagnosis and a same-day fix in most cases.
Do you replace well pumps or just pressure tanks?
Both. We repair and replace pressure tanks, switches, controls and check valves, and replace failed submersible and jet pumps. Well drilling and casing repair are referred to a well driller.
How long does a pressure tank replacement take?
Typically two to three hours, including draining the system, setting the new tank, switch and gauge, and restoring water.
Can low water pressure be fixed without a new pump?
Often. A clogged sediment filter, an incorrectly set pressure switch, a waterlogged tank or a partly closed valve are all common causes we fix without replacing the pump.
Which areas do you cover for well service?
Augusta, Manchester, Winthrop, Hallowell, Farmingdale, Gardiner, Waterville and the surrounding towns — most of which have homes on private wells.
More Services in Bath
RJC Plumbing handles every plumbing need for Bath homeowners, not just well pump repair.
Need Well Pump Repair in Bath?
Call now or request a free estimate below, and we will get back to you promptly.
Get a Quote for Well Pump Repair in Bath
Fill out the form or call (207) 549-0064 and we will get back to you promptly.
More ways we can help
Google reviewsService areas
17The same service reaches nearby communities such as
- Central Maine service areas
- Plumber in Augusta, ME
- Plumber in Brunswick, ME
- Plumber in Waterville, ME
- Plumber in Gardiner, ME
- Plumber in Hallowell, ME
- Plumber in Winthrop, ME
- Plumber in Farmingdale, ME
- Plumber in Manchester, ME
- Plumber in Winslow, ME
- Plumber in Oakland, ME
- Plumber in Topsham, ME
- Plumber in Bath, ME
- Plumber in Lewiston, ME
- Plumber in Auburn, ME
- Plumber in Lisbon, ME
- Plumber in Sabattus, ME
Guides & tips
4Learn more from our plumbing guides, including
Company
4Get to know RJC Plumbing through
Plumbing services
10Homeowners often pair this with our other work, such as